Monitor charge of a 12.8 V / 13.2 V lithium battery.
This monitor confirms that the vehicle loading system is working correctly. Checks the status of a 12,8 V / 13,2 V Lithium battery.
LENGTH: 40 inches / 100 cm
INPUT: 1/4″ (M6)
OUTPUT: SAE 2-pins
FUSE: 15 Amp
CABLE: SPT-2W 16 AWG (1.32mm2)
USE: Suitable for use at very low temperatures down to -40 ° C / -40 ° F, cable remains flexible at temperatures below “freezing point”
OTHER: Fully enclosed electronic module with 4 LEDs, SAE charging connector with waterproof rubber cover
OPERATION: Two automatic modes - battery charge level check (one flashing LED) and system test while charging (arrow mode)
VEHICLE STORAGE: Four LEDs show the voltage range, from full to empty, of 12.8V / 13.2V lithium batteries ( LFP / LiFePO4 / lithium nanophosphate); the fourth led warns when the system or the connected battery charger OVERCHARGES! The LED corresponding to the charge level will blink every ten seconds (long-term recording is less than 0.2mA)
VEHICLE RUNNING: LED arrow mode turns on when the charge voltage is within the ideal lithium charge range of 14.2V-14.5V (√ green led). The "OVERCHARGE" warning is triggered at more than 14.6V
Excluding VAT and transport costs